Skip to content

GetFPV

TIGER MOTOR M5 CW PROP ADAPTER NUT

,

Details One 5mm Clockwise Thread Nut/Prop Adapter for MT series ...

GetFPV

TIGER MOTOR 20 AMP ESC

OutputContinuous 20 amps, burst ~22 amps up to 10 Seconds
Input Voltage2-4 cells Lipo battery or 5-12 cells NiCd/NIMh battery
BEC2A / 5V (Linear mode)
Size35mm (L) * 29mm (W) * 8mm (H)
Weight24g
Multiple protection featuresLow-voltage cut-off protection / over-heat protection / throttle signal loss protection
3 start modesNormal / Soft / Super-Soft, compatible with fixed-wing aircrafts and helicopters.
Details This is a high quality, 20 amp ESC by ...

GetFPV

TIGER MOTOR MT-4006 SERIES BEARINGS

,

Details Tiger Motor upper and lower replacement bearings for the ...

GetFPV

TIGER MOTOR M5 CW PROP ADAPTER FOR CARBON FIBER PROPS

,

Details One 5mm Clockwise Thread Nut/Prop Adapter for MT series ...

GetFPV

TIGER MOTOR M6 CW PROP ADAPTER FOR CARBON FIBER PROPS

,

Details One 6mm Clockwise Thread Nut/Prop Adapter for MT series ...

GetFPV

TIGER MOTOR MN-4012 + 4014 SERIES BEARINGS

,

Details Tiger Motor upper and lower replacement bearings for the ...

GetFPV

TIGER MOTOR MT-2212-11 1100KV

,

Details The Tiger T-Motor MT series motors are specifically designed ...

GetFPV

TIGER MOTOR M6 CCW PROP ADAPTER FOR CARBON FIBER PROPS

,

Details One 6mm Counter-Clockwise Thread Nut/Prop Adapter for MT series ...

GetFPV

TIGER MOTOR M5 CCW PROP ADAPTER FOR CARBON FIBER PROPS

,

Details One 5mm Counter Clockwise Thread Nut/Prop Adapter for MT ...

GetFPV

TIGER MOTOR M6 CCW PROP ADAPTER NUT FOR MT-3515 MOTORS

,

Details One 6mm Counter Clockwise Thread Nut/Prop Adapter for MT-3515 ...

GetFPV

TIGER MOTOR CARBON FIBER PROP MOUNTING ACCESSORIES

,

Details A set of T-Motor Carbon Fiber Prop mounting hardware ...

GetFPV

ALEXMOS 3RD AXIS EXTENSION BOARD

,

Details An extension board for the AlexMos Brushless Gimbal Controller ...

GetFPV

DJI WOOKONG MULTI-ROTOR AUTOPILOT

Stop MotorTwo provided options to stop motors

Start Motor: When using WKM, pushing throttle stick before takeoff will not start motors. You have to execute any one of following four Combination Stick Commands (CSC) to start motors.,

Details WooKong-M is a complete flight control system for all ...

GetFPV

DJI NAZA M MULTI-ROTOR STABILIZATION CONTROLLER AND GPS/COMPASS

Naza-M offers three types of control modes: GPS Atti. Mode(with GPS module), Atti. Mode, Manual Mode. Switch among the three modes to adjust to different flight environments. Naza-M can adjust automatically and intelligent switch between GPS Atti.mode and Atti. Mode to ensure the safety and security of the flight., Immediately Mode: By using this mode once the motors start and throttle stick has exceeded 10%, motors will stop immediately when throttle stick is back under 10% again. In this case, if you push the throttle stick over 10% within 5 seconds of the motors stopping, motors will re-start .If you don’t push throttle stick within three seconds of the motors starting, the motors will stop automatically., Intelligent Mode: In Manual, only executing CSC will stop motors. In Atti Mode. any one of following four cases will stop motors:, a) You don’t push throttle stick after motors start in three seconds;,

Details NAZA simplifies installation on your multi-rotor; saving space and ...

GetFPV

DJI NAZA M MULTI-ROTOR STABILIZATION CONTROLLER

Naza-M offers three types of control modes: GPS Atti. Mode(with GPS module), Atti. Mode, Manual Mode. Switch among the three modes to adjust to different flight environments. Naza-M can adjust automatically and intelligent switch between GPS Atti.mode and Atti. Mode to ensure the safety and security of the flight., Immediately Mode: By using this mode once the motors start and throttle stick has exceeded 10%, motors will stop immediately when throttle stick is back under 10% again. In this case, if you push the throttle stick over 10% within 5 seconds of the motors stopping, motors will re-start .If you don’t push throttle stick within three seconds of the motors starting, the motors will stop automatically., Intelligent Mode: In Manual, only executing CSC will stop motors. In Atti Mode. any one of following four cases will stop motors:, a) You don’t push throttle stick after motors start in three seconds;,

Details NAZA simplifies installation; saving space and weight. With the ...

BevRC DPCAV Hobby-Lobby HobbyKing LowPriceRC ngHobbies NitroTek R2Hobbies RangeVideo RCTimer ReadyMadeRC HobbyWireless RCPlanet HorizonHobby HiModel OFM GetFPV AMainHobbies SDSHobby GoodLuckBuy Flying-Hobby